Isspro R8861HV Uživatelský manuál stáhnout pdf

ISSPRO, INC. 2515 N.E. Riverside Way, Portland OR 97211

Telephone: (503) 288-4488  Toll Free: (800) 888-8065

FAX: (503) 249-2999

ISSPRO Hourmeter Instructions

Connecting Meter and Pressure Switch:

For battery equipped systems with magneto ignition, connect one wire to any

convenient point on the engine or vehicle frame. Connect the other wire to

either terminal of ISSPRO’s Pressure Switch. Connect the other lead of the

pressure switch to the hot side of the ammeter, generator, or battery. For

pressure switch installation, refer to the instructions with the ISSPRO switch.

Connecting Meter by Other Methods:

For battery powered ignition systems, connect one wire to any convenient point

on the engine or vehicle frame. Connect the other wire to the ignition switch.

Information:

This meter has been designed to withstand vibration, however, it should

preferably be mounted in a location where there is a minimum amount of

vibration, such as an instrument panel. Where excessive vibration is

encountered, a vibration damper should be used. A damper designed for this

meter is available.

On magneto ignition systems, the pressure switch must be used. In normal

operation, the meter may continue to operate for a short time after the power is

turned off. For standard meter use, cut out and bolt circle as shown. For a

clamp mounted meter, use a 2.00” diameter hole only.

Printed in the USA Form No. IS080 (6/25/08 Rev. C) Page 1 of 2

ISSPRO, INC. 2515 N.E. Riverside Way, Portland OR 97211

Telephone: (503) 288-4488  Toll Free: (800) 888-8065

FAX: (503) 249-2999

ISSPRO Hourmeter Instructions

Connecting Meter and Pressure Switch:

For battery equipped systems with magneto ignition, connect one wire to any

convenient point on the engine or vehicle frame. Connect the other wire to

either terminal of ISSPRO’s Pressure Switch. Connect the other lead of the

pressure switch to the hot side of the ammeter, generator, or battery. For

pressure switch installation, refer to the instructions with the ISSPRO switch.

Connecting Meter by Other Methods:

For battery powered ignition systems, connect one wire to any convenient point

on the engine or vehicle frame. Connect the other wire to the ignition switch.

Information:

This meter has been designed to withstand vibration, however, it should

preferably be mounted in a location where there is a minimum amount of

vibration, such as an instrument panel. Where excessive vibration is

encountered, a vibration damper should be used. A damper designed for this

meter is available.

On magneto ignition systems, the pressure switch must be used. In normal

operation, the meter may continue to operate for a short time after the power is

turned off. For standard meter use, cut out and bolt circle as shown. For a

clamp mounted meter, use a 2.00” diameter hole only.

Printed in the USA Form No. IS080 (6/25/08 Rev. C) Page 1 of 2

1 2

Shrnutí obsahu

Strany 1

ISSPRO, INC. 2515 N.E. Riverside Way, Portland OR 97211 Telephone: (503) 288-4488  Toll Free: (800) 888-8065 FAX: (503) 249-2999 ISSPRO Hourmet

Strany 2

ISSPRO Limited Warranty ISSPRO, Inc. warrants to the consumer that its hourmeters will be free from defects in materials and workmanship for 12

Komentáře k této Příručce

Žádné komentáře